- Perth / Perkins original spare parts
- Perkins repair parts inquiry
- Perkins Parts Service Center
- Perkins Parts System Atlas
- Caterpillar .CAT Diesel Engine Parts
- john deerejohn deere accessories
- Mitsubishi Engine Parts Center
- Genuine Volvo diesel engine parts
- Qianglu Diesel Engine Parts Maintenance Technology
- Perkins Technology Center
- Cummins engine generator parts
- Mitsubishi Diesel Engine Generator Maintenance
- Perkins engine parameters
- Perkins / Perkins industrial engines
- The parameters of the British Willson generator set
- Generator Leasing Service Center
- Volvo diesel generator set
- Diesel generator grid-connected and parallel
- Cummins diesel generator set
- Japan Mitsubishi Diesel Generator Set
- Caterpillar generator set
- Generator dual power conversion cabinet ATS
:0574-26871589 Unit sales : 0574-26871589
:0574-26886646 Accessories Sales : 0574-26886646
:0574-26871569 Maintenance Hotline : 0574-26871569
pass :0574-26892499 True : 0574-26892499
Ground : 宁波戚家山联合路 246-252 号 Address : No. 246-252 , Lianhe Road, Qijiashan , Ningbo
Installed Mitsubishi S6R diesel engine fuel injection pump
(a) The connecting bolts (long) of the drive coupling and the lamination are all loosened after tightening to the specified torque, and tightened again with the specified torque. (2 tightenings)
(b) If the joint surface of the drive coupling and the lamination is embedded, it may cause slippage or damage, and the bolts, bushes and washers should be cleaned before use.
(c) After the coupling is tightened, if the laminations are twisted or deformed, they should be tightened again.
(1) Lift the fuel injection pump of Mitsubishi S6R diesel engine. Slowly suspend the fuel injection pump of the Mitsubishi S6R diesel engine, align it with the positioning pin of the pump seat and install it.
(2) Connect the lamination and the drive coupling and temporarily fix them with bolts. At this time, confirm that the Mitsubishi S6R diesel engine crankshaft is at the top dead center position of No.1 cylinder compression, and the "0" engraved line of the Mitsubishi S6R diesel engine fuel injection pump Mitsubishi S6R diesel engine flywheel is close to the pointer.
Note: When installing the connecting bolts of each coupling, be careful not to forget to install the bushings and washers and pay attention to the installation direction.
(3) Adjust the gap between the drive coupling and the Mitsubishi S6R diesel engine flywheel to a standard value. For the adjustment method, please refer to the item "Adjustment of the gap between the flywheel and the drive shaft coupling of the fuel injection pump Mitsubishi S6R diesel engine".
(4) All bolts and nuts temporarily tightened by each coupling are tightened to the specified torque.
(5) Check the clearance of each coupling and the bolt tightening status of each part again.
(6) Install the bracket between the injection pump casing and the Mitsubishi S6R diesel engine crankcase.
(7) Replenish the engine oil from the cam chamber lube oil pipe mounting hole.
(8) Install the oil pipe and fuel pipe.